Soft fascia, sagging soffit, rotted door jambs, and crumbling trim — we cut out the bad wood, replace with new, prime all six sides, and leave it paint-ready.
Fully insured · 1-year workmanship warranty · Free phone quotes in under 5 minutes
Cut out, don't cover up
Soft wood replaced with fresh lumber. Filler-only fixes return within a year — we don't do them on structural areas.
Source of the leak addressed
Most fascia rot has a cause: gutter, flashing, or transition. We point it out so the rot doesn't come back.
Primed on all six sides
Florida humidity attacks bare wood fast. Every replacement gets sealed before it goes up.
Wood rot jobs we see across Venice
Fascia behind clogged gutters, soffits under leaky flashings, and exterior door jambs at the bottom hinge — these three account for most calls.
BeforeAfter
Fascia & Soffit Replacement
The classic Florida rot job. Clogged gutters overflow behind the fascia, the wood goes soft, paint fails, and it spreads to the soffit. We pull the gutter, cut out the bad fascia, replace with primed PVC or PT lumber, re-hang the gutter, and re-paint to match.
Gutter removed and re-hung after
PVC trim or pressure-treated 1x8/1x10
Soffit panels replaced if rot has spread
Paint matched to existing trim color
BeforeAfter
Door Jamb & Threshold Repair
Exterior door bottom hinges and thresholds rot from rain splash and standing water. We cut out the bad section of jamb (usually bottom 12–18"), splice in new primed jamb stock, replace the threshold if needed, and re-weatherstrip so it stays sealed.
Bottom-of-jamb splice with primed jamb stock
Threshold replacement when corroded
Fresh weatherstrip and door sweep
Door re-hung level and latching cleanly
BeforeAfter
Exterior Trim & Window Casing
Window casings, garage door trim, column wraps, and decorative brackets. We cut out soft sections, replace with primed PVC or cedar, caulk every seam with 50-year urethane, and paint to match the existing color.
PVC trim where it's available — won't rot again
50-year urethane caulk at every seam
Color match to your existing trim paint
Garage door trim and column wraps included
Service areas across Sarasota County
Based in Venice and serving homes from Sarasota down to Englewood. If you're inside Sarasota County, we'll be there.
Venice, FL
Home base — Venice Island, East Venice, South Venice, and Jacaranda.
Sarasota, FL
Palmer Ranch, Gulf Gate, and the southern Sarasota neighborhoods.
North Port, FL
All zip codes — Sumter, Toledo Blade, West Villages, Wellen Park.
Nokomis & Osprey
Bayfront homes and the gated Oaks and Sorrento communities along the Intracoastal.
Englewood, FL
Manasota Key cottages and inland Rotonda West and Englewood East.
Why Florida wood rot spreads fast
Florida humidity sits over 70% most of the year. Once wood gets wet and doesn't dry out — behind a clogged gutter, under a missing flashing, around a failing caulk bead — fungal rot takes hold within months, not years. By the time you see paint bubbling, the wood underneath is usually mush.
The fix that lasts is replacement, not filler. Epoxy and bondo are fine for cosmetic divots in dry, non-structural trim, but on fascia, jambs, and structural casing they just trap moisture and make the next round worse.
And whenever we can, we swap the rotted wood for PVC. PVC trim costs a little more up front, looks identical to wood after paint, and literally cannot rot. On fascia and exterior casing it's a one-time fix.
Venice wood rot repair, neighborhood by neighborhood
Rot in Venice is almost always a water path, not bad lumber. Where the water comes from depends on the age of the house and how close it sits to the Gulf.
Venice Island & Golden Beach
What we run into: Older wood-framed and wood-sided homes where fascia, window sills, door casings, and porch columns take the west sun and the salt air together.
How we handle it: Rot probed to find the full extent instead of cutting to the visible damage, replacement in matching profile so the historic look holds, and end grain primed on all sides before it goes up.
Venice Gardens & South Venice
What we run into: Mid-century block homes where the wood is limited to fascia, soffit trim, and garage door jambs, and the rot almost always starts at a gutter overflow or a failed caulk joint.
How we handle it: The water source fixed in the same visit where we can, fascia replaced behind the gutter rather than face-nailed over, and joints sealed with a flexible sealant instead of painters caulk.
Jacaranda & Auburn corridor
What we run into: Oak canopy keeps fascia, deck boards, and shaded trim damp for days after rain, and mildew hides the early soft spots until a board flexes underfoot.
How we handle it: Every shaded elevation checked rather than only the reported spot, deck boards flipped or replaced where the underside is gone, and shaded wood treated with a borate before it is primed and painted.
Nokomis & Osprey
What we run into: Canal and bayfront homes with docks, exterior stairs, railings, and gates in constant salt and splash, where fasteners rust out and open the grain to water.
How we handle it: Stainless fasteners and marine-grade hardware on every replacement, structural members checked before cosmetic trim, and pressure-treated or composite recommended where the exposure will beat any paint job.
Wellen Park & Grand Palm
What we run into: Newer builds where rot shows up early at exterior door thresholds, garage jambs, and lanai posts because flashing or a caulk joint was missed at construction.
How we handle it: Flashing detail corrected instead of just replacing the wood, thresholds re-bedded so water drains out rather than in, and any builder detail we correct documented with photos for your records.
Venice condos & HOA properties
What we run into: Shared exterior wood such as walkway railings, stair stringers, and trellises, where structural repairs need board sign-off and often a documented scope.
How we handle it: Written scope and photos provided for the board, structural repairs made to code with proper fasteners, and the finish matched to the building standard so one unit does not stand out.
Do not see your street? We work across all of Venice, Venice Island, Venice Gardens, South Venice, Nokomis, Osprey, Laurel, and Wellen Park — call 941-928-1485 and describe your home, and we will tell you what to expect before anyone comes out.
Frequently asked
Questions Venice homeowners ask us
Straight answers — the same ones we give over the phone before a job goes on the calendar.
How much does wood rot repair cost in Venice, FL?
Small soft spots and individual trim pieces typically run $175–$400 per section. Multi-board fascia runs or large soffit replacements are quoted on-site after we sound out the extent — most fall between $450 and $1,500.
Do you replace the rotted wood or just fill it?
If the rot is structural or covers more than a couple square inches, we cut it out and replace with new lumber — that's the only fix that lasts. Tiny soft spots in non-structural trim can be epoxy-filled and sanded, and we'll tell you which approach makes sense.
Will you paint the replacement to match?
We always prime the replacement on all six sides before installing — that's what makes it last in Florida. Color top-coating is optional: we can match and paint, or leave it primer-ready for your painter.
How fast can you start?
Most Venice wood rot jobs are on the calendar within 3–5 days. Active leaks or rot around an exterior door that won't close get prioritized — call directly and we'll work you in.
Do you do fascia replacement around the whole house?
Yes, on single-story homes and most two-story side-yards we can reach with our ladder setup. Very tall two-story front or rear elevations may need scaffold rental, which we'll line up if needed.
Can you find the leak that caused the rot?
Often yes — most fascia rot comes from a clogged gutter, a missing kickout flashing, or a failing soffit transition. We point out what we see and recommend the fix so the rot doesn't come back.
Why does exterior wood rot so fast in Florida?
Three things: 90%+ summer humidity, daily afternoon rain driven sideways by wind, and irrigation overspray hitting unsealed wood. Rot starts wherever paint film fails — corner joints, nail heads, fascia/gutter contact points — and spreads inward in 18–36 months. Catching it early is the difference between a $300 trim board and a $1,500 framing repair.
Do you replace fascia, soffit, corner boards, and window sills?
Yes — all four. We cut out the rotted section back to sound wood, treat the adjacent framing with a borate wood preservative, install primed PVC or pre-primed pine (whichever is appropriate for the location), prime all cut ends, caulk, and paint to match. Done right it won't come back for a decade-plus.
Should I use PVC trim instead of wood for repairs?
On exterior trim that gets sun, splash, or ground contact — yes. PVC (Azek, Versatex, Kleer) doesn't rot, won't be eaten by termites, and holds paint indefinitely in Florida sun. We use PVC anywhere it's visually correct and pre-primed wood where it has to match an adjacent profile we can't get in PVC.
How fast can you start a job in Venice?
Most Venice and South Venice jobs go on the calendar same-day or next-day. Sarasota and Englewood typically schedule within 48 hours. If it's an emergency — active leak, broken exterior door, storm damage — call directly and we'll try to fit you in the same day.
Do you give estimates over the phone or do I need to schedule a visit?
For most repairs we give an honest ballpark over the phone in under five minutes — you describe what's going on and we tell you a price range based on what we typically see. For larger projects (full repaints, multiple-room work, deck rebuilds) we'll come out and walk it with you. Phone estimates are always free; on-site estimates are free for projects we end up booking.
Are you licensed and insured?
Yes — fully insured for residential and HOA work across Sarasota County. Florida doesn't require a handyman license for repair work under specific thresholds, but we carry general liability and we're happy to send our certificate of insurance to your HOA or condo board before we start.
What forms of payment do you accept?
Cash, check, Zelle, Venmo, and all major credit cards. No deposit required on small jobs — we invoice when the work is done and you're happy with it. Larger projects with material purchases may require a materials deposit, which we'll discuss up front.
Do you stand behind your work?
Every repair comes with a one-year workmanship warranty. If something we fixed comes back within twelve months, we come back and make it right — no callback fee, no excuses. That's the whole reason we're called Fix It Once.
Can I bundle multiple small fixes into one visit?
Yes — and you should. Most of our Venice customers save a trip charge by stacking a punch list: a sticking door, a wobbly fan, a leaky hose bib, a wall patch, a new mailbox. One trip, one invoice, the whole list done.
Do you work inside Venice HOAs and gated communities?
Yes — we work inside The Plantation, Venice Golf & Country Club, IslandWalk, Renaissance, Pelican Pointe, and most of the gated Wellen Park communities. We keep approved paint codes and mailbox specs on file, and we'll send our certificate of insurance to your board before the first visit.
Are you on Venice Island for smaller cottage and condo jobs?
Often — Venice Island is a 10-minute drive from our shop. We handle the tight-access trim, plaster, and salt-rot work that bigger crews skip, and we know the loading and parking rules for the downtown condos.
How fast can you get to Wellen Park or South Venice?
Wellen Park (IslandWalk, Renaissance, Solis, Sunstone) and South Venice usually get same-week scheduling — most jobs on the calendar within 2–4 days. Warranty-period punch lists on new builds are something we book all the time.
What's the cost of an after-storm repair visit in Venice?
After a named storm we triage by urgency, not by call order — active leaks, blown lanai screens, and broken exterior doors go first. The trip charge is the same as a normal visit, and we'll quote the repair on site before any work starts.
Venice neighborhoods we cover
Wood Rot Repair in Venice, FL across every corner of Venice, FL
From Venice Island west of the Intracoastal to Wellen Park down south, here are the Venice neighborhoods we cover most weeks — with the quirks we plan around on every job.
Venice Island
34285
Historic Mediterranean-revival cottages and waterfront condos west of the Intracoastal. Salt-air rot, brittle caulk lines, and original 1950s–60s fixtures are the usual call.
South Venice
34293
Block-built ranch homes off Englewood Road. Older roofs, plenty of mature oaks dropping debris in the gutters, and HOA-free yards that let us work without waiting on board approval.
East Venice & Jacaranda
34292
1990s–2000s subdivisions along Jacaranda Blvd — Venice Gardens, Waterford, Sawgrass. Cement-board siding, lanai screens, and original builder-grade interior doors are the regulars.
Venice East & The Plantation
34292
Gated golf communities with strict HOA color and material specs. We keep paint codes, mailbox specs, and approved trim profiles on file so jobs don't get red-tagged.
Gulf View & Venezia Park
34285
Walkable historic district between downtown and the beach. Smaller bungalow footprints, tight side yards, and a lot of interior trim and plaster work.
Wellen Park (West Villages)
34293
New-build neighborhoods south of US-41 — IslandWalk, Renaissance, Sunstone, Solis. Warranty-period punch-list work, ceiling-fan installs, and TV mounts in the great room are the typical jobs here.
Recent Venice projects
What this month looked like in Venice
A sample of the actual jobs we knocked out around Venice recently — the kind of work most homeowners around here need at one point or another.
South Venice
Lanai re-screen after Hurricane Milton
Replaced four blown panels and re-splined the entire cage on a Lemon Bay Drive ranch — back tight before the homeowner's snowbird arrival.
The Plantation
HOA-spec mailbox swap
Set a new 6x6 cedar post in 80 lbs of concrete with the community-approved black aluminum mailbox and gold reflective numbers — passed HOA inspection same week.
IslandWalk, Wellen Park
Drywall + paint touch-up on a new build
Patched two corner-bead cracks and a doorknob blowout, color-matched the builder Sherwin Williams white, and rolled the affected walls corner to corner so the repair vanished.
Venice Island
Salt-air door re-finish
Stripped, sanded, and re-stained a sun-faded mahogany front door on a Tarpon Center condo, then sealed with marine-grade UV spar varnish for the Gulf exposure.
East Venice / Jacaranda
Rotted fascia replacement
Cut out 16 ft of soft fascia behind the gutter, swapped to PVC trim, re-secured the drip edge, and painted to match. Done before the next afternoon storm.
Venezia Park
Original 1960s ceiling fan swap
Pulled three brittle original fans on existing wiring, installed modern DC-motor replacements with remotes, and balanced each blade set so they run silent on high.
More Venice services
Other repairs we handle in Venice, FL
One call, one crew, one invoice — stack any of these onto your visit.